Switch-Pros Ground Wiring Harness

So you bought a Switch-Pros RCR 12 or a 9100 8-circuit Power Distribution Module (PDM) and are ready to wire it. But what will you do with all the ground wires from all the accessories you will now power? Don't worry—we've got you with our Switch-Pros Ground Wiring Harness.

Our pig-tailed harnesses are sized for the maximum current draw of each circuit with pre-terminated connectors, so you don't have to buy expensive terminal crimpers. They will be presented in 2 lengths to suit either the two-seaters at 5' and the four-seaters at 10' and will include soldered heat shrink butt connectors so each circuit can be cut to length. The harness kits can also include connectors at the accessory end to unplug accessories for maintenance.

The harness includes connectors at the ground block end that are terminated and ready to plug into our ground blocks. It can also include 14 and 10-AWG wire in five or ten-foot lengths at your specified length.

What comes in the box

• Female connectors with pigtailed wire terminated and ready to plug in.
• Butt Splice connectors that are equipt with solder and heat-shrink. No crimpers are needed, just a heat gun or butane lighter.
• 1 Female connector for the start switch on all Can-Am models with a push-to-start switch

If ordered with accessory connectors, it will addon

For the 9100 8ch.

• 4 20A male and female sealed connectors with 6-inch long 14AWG leads. 
• 4 30A male and female sealed connectors with 6-inch long 10AWG leads.
• 8 Sealed heat-shrink solder butt connectors.

For the RCR 12ch.

• 11 20A male and female sealed connectors with 6-inch long 14AWG leads. 
• 5 35A male and female sealed connectors with 6-inch long 10AWG leads. 
  
• 32 Sealed heat-shrink solder butt connectors.

Extra connectors added on will also include

• Preterminated and wired sealed connector with 6-inch long leads.
• 4 Sealed heat-shrink solder butt connectors appropriately sized for selected connectors.